Richie Ramos (gaijin@i-manila.com.ph)
Thu, 5 Oct 2000 03:10:13 GMT


> no, it can be done. The MSiA Tallgeese action figure has removeable beam

>saber blades, so it can store the saber hilts in it's shield. MSiA's are
>smaller then 1/144 kits. Yes, I know how the MG kit's hilts are made. The

>MSiA Tallgeese's blades have a peg that snaps into the saber hilts. So since

>it's done on an MSiA, it can be done in 1/144, no doubt about it.
>Aaron
>"Believing a sign of Zeta"

I think the question is whether or not it will look technical enough. Just
my 2 cents there....

If I wanted to rage against the dying of the light, I would have brought a
flashlight.

Richard "Richie" Ramos, Associate Editor
Localvibe -- Changing the way you see your city!
www.localvibe.com
ofc: (632) 4167486, DL (632)4485473 / fax: (632) 4167479
cel: 0917-4024780 / hse: (632) 7231308 (emergency use)
ICQ#: 12914919

I am NOT a starving writer.

=============================================================
This message was sent using I-Mail ( http://www.i-mail.com.ph )
Internet Manila's Web-Based E-Mail interface
=============================================================

-
Gundam Mailing List Archives are available at http://gundam.aeug.org/



This archive was generated by hypermail 2.0b3 on Thu Oct 05 2000 - 11:59:08 JST