Gus Jae (gusjae@channel1.com)
Sun, 19 Sep 1999 10:43:45 -0400


The best way to cut the thin rubber part is to use a sharp #10, not 11
blade. If possible, don't cut right up to the part the first time. Trim as
you go. Never fails with practice.
Good luck
Gus Jae
gusjae@channel1.com
----- Original Message -----
From: <Chaos025@aol.com>
To: <gundam@aeug.org>
Sent: Saturday, September 18, 1999 7:16 PM
Subject: Re: [gundam] MG Alex

> In a message dated 9/18/99 8:30:28 AM Mountain Daylight Time,
> mhanyo1@umbc.edu writes:
>
> > you mean like the gelgoog kits? I thought that the "rubber cloth" was
rather
> > annoying with those ones. Sure, when you were done with it it looked
great,
> > but cutting them correctly and all that proved to be way more trouble
than
> I
> > had expected.
>
> I had no problems, and I think it looks great. I just followed the
> instructions (well picture, anyway), and cut where the diagram indicated.
And
> it looks great.
>
> SJ
>
> -
> Gundam Mailing List Archives are available at http://gundam.aeug.org/
>
>

-
Gundam Mailing List Archives are available at http://gundam.aeug.org/



This archive was generated by hypermail 2.0b3 on Sun Sep 19 1999 - 23:44:36 JST