Richie Ramos (gaijin@i-manila.com.ph)
Sun, 05 Sep 1999 20:46:37 +0800


>I have noticed that lately, more and more parts are getting heavier then
>what the little poly cap can support. One thing that I have been doing is
>regardless lose or tight, I have been putting some white glue into the hole
>on the plastic piece and then set the poly cap in, moving it after it dries.
>So far, no too bad. And one else have any other ideas? The prime guilty
>party are the elbow joints.
>Gus Jae
>gusjae@channel1.com

hmmmm...aside from using superglue/cyanoacrylic glue (which doesn't stick
to polycaps), I would also advise some putty...white glue can be a bit too
fragile sometimes.

"Magic is the hand of faith..."

Richard Ramos
Svengali, Artificer and Spellcrafter
ICQ#12914919
(You guys can also see some of my writing at http://www.localvibe.com -
Changing The Way You See Your City! Metro Manila's Premier On-line
City-Guide and Lifestyle Magazine)

-
Gundam Mailing List Archives are available at http://gundam.aeug.org/



This archive was generated by hypermail 2.0b3 on Sun Sep 05 1999 - 21:58:37 JST