Gus Jae (firstname.lastname@example.org)
Sat, 4 Sep 1999 20:58:01 -0400
I have noticed that lately, more and more parts are getting heavier then
what the little poly cap can support. One thing that I have been doing is
regardless lose or tight, I have been putting some white glue into the hole
on the plastic piece and then set the poly cap in, moving it after it dries.
So far, no too bad. And one else have any other ideas? The prime guilty
party are the elbow joints.
Gundam Mailing List Archives are available at http://gundam.aeug.org/
This archive was generated by hypermail 2.0b3 on Sun Sep 05 1999 - 09:56:37 JST