Fri, 25 Jun 1999 11:59:39 EDT

In a message dated 6/25/99 1:57:39 AM Mountain Daylight Time, writes:

> Well I recently started on a HG 1/100 Tallgees III and I was having trouble
> with using the putty part in the cracks, I apply it and sand it off when
> dries, but when I spray paint it there still remains this grey thin line
> where the putty was left. Could anyone please give some advice as to the
> of putty in models?

You should primer to piece after you're done with the putty. When the primer
dries, any paint you apply should be applied in thin layers until there is no
signs of discoloration left on the piece.


Gundam Mailing List Archives are available at

This archive was generated by hypermail 2.0b3 on Sat Jun 26 1999 - 01:02:39 JST