Re: [gundam] Wing plated kits?


Prabal Nandy (nandy@U.Arizona.EDU)
Tue, 6 Apr 1999 11:03:38 -0700 (MST)


> Is there any way to finish one of these kits without the scars caused by the
> sprue joinings?
> Or failing that, any way to cover up these areas when finished?

  Well, the classic answer is "no", you have to putty, sand prime and
completely cover over the sprue-scars. In reality, for _certain_
kinds/colors of plastic, you can sand the 'bump' down, and then apply a
little dab of clear-coat (future floor wax) which fills-in the scar and
blends it into the rest of the surface. Alternately, if you're feelin'
lazy, you can dab just a touch of drybrushed paint of the same color over
the scar area and at least from arm's-legnth away it will look okay. But
as always, the best solution is to repaint the entire damn thing.
        
                                                        -Probe

-
Gundam Mailing List Archives are available at http://gundam.aeug.org/



This archive was generated by hypermail 2.0b3 on Wed Apr 07 1999 - 03:04:12 JST