Re: [gundam] PG sticker?


Chaos025@aol.com
Sun, 28 Mar 1999 01:18:40 EST


In a message dated 3/27/99 6:19:16 PM Mountain Standard Time, alex-
ag@centrin.net.id writes:

> Hey how to use the PG sticker that is have to use with water? and how to
> stick it to the parts?
>
> Alex
>

If you are asking about how to use water slide transfers, you cut out the
transfer you are going to place and put it in a dish of water. In a few
minutes, the transfer will peel off the paper. You then place the transfer on
the model. Use an exacto knife for adjusting the placement as tweezers may
damage the transfer, then soak up the water in the transfer with some tissue
paper. Let it dry for about twenty minutes or so, then see if you need the do
any touchups with paint. Then all you need to do now is seal the model.

SJ
-
Gundam Mailing List Archives are available at http://gundam.aeug.org/



This archive was generated by hypermail 2.0b3 on Sun Mar 28 1999 - 15:20:33 JST